Use QA Mode for a more effective QA process. When QA Mode is enabled:

  • You can hover over an instance to see its class and attribute(s) (if available).
  • When you hover over an instance in the right panel, it'll be the only one visible on the image.

Enable QA Mode

To enable QA Mode, turn on the QA Mode toggle in the left panel of the Vector Editor or press Shift+Q on the keyboard.

Switch between instances

You can switch between instances to make the QA process more effective.

Press Tab on the keyboard to switch to the next instance and Shift+Tab to switch to the previous instance. When you do that, you'll zoom in on the instance, allowing you to check and edit it with higher precision.

When you switch between instances, the order is as follows:

  • Switching to the next instances: from the top of the instances list in the right panel (or from the selected instance) to the bottom.
  • Switching to the previous instances: from the bottom of the instances list in the right panel (or from the selected instance) to the top.